Map sensor help
Thread Starter
Registered User
Joined: Nov 2016
Posts: 57
Likes: 0
Map sensor help
yes i searched bahahahaha.
I have an AP2 doing a turbo build. I will be running an aem ems series 2 I purchased a science ofspeed 4 bar map sensor. When i recieved it the sheet it comes with says its not compatible with the series 2. Talked to sos and the said i need to run dual map sensors. One wired into the aem ems for boost and that i need to retain my stock map sensor but i need to find a map blocker so the stock map doesnt read boost. Kinda confused. never ran into this problem. Any help or input would be appreciated. Anyone else running a series 2? ill be boosting at around 15 pounds. I was thinking about just getting a gm 3 bar because i know the ecu is capable or reading that. Just confused about the stock map? Ive always just ran a upgraded map and ditched the stock unit
I have an AP2 doing a turbo build. I will be running an aem ems series 2 I purchased a science ofspeed 4 bar map sensor. When i recieved it the sheet it comes with says its not compatible with the series 2. Talked to sos and the said i need to run dual map sensors. One wired into the aem ems for boost and that i need to retain my stock map sensor but i need to find a map blocker so the stock map doesnt read boost. Kinda confused. never ran into this problem. Any help or input would be appreciated. Anyone else running a series 2? ill be boosting at around 15 pounds. I was thinking about just getting a gm 3 bar because i know the ecu is capable or reading that. Just confused about the stock map? Ive always just ran a upgraded map and ditched the stock unit
Joined: Dec 2015
Posts: 812
Likes: 119
You can hit me up on the topic if you want.
I do a lot of S2ki member tunes on v1/v2
i always suggest Omni 4 bar, and you’ll never need to buy another Map sensor again. And it works fine
with v2
if you wanna chat more txt me
7173986782
I do a lot of S2ki member tunes on v1/v2
i always suggest Omni 4 bar, and you’ll never need to buy another Map sensor again. And it works fine
with v2
if you wanna chat more txt me
7173986782
Registered User
Joined: Mar 2015
Posts: 371
Likes: 9
If u're going to over 600hp + u need 4 bar map sensor or over 26psi of boost. U replace our ap2 map sensor. I bought sos 3 bar map sensor and Max psi reading is 26psi of boost. I'm currently on street set up daily driven 19psi at 600ponies. Best advice pick a tuner tell them what u want then they'll help with set-up and tune
Thread
Thread Starter
Forum
Replies
Last Post
