Originally Posted by passmans2kny

I am getting nothing on the cluster, the speedo healer is seeing 12v from the o2 sensor that wasnt being used, I ran test mode on the speedo healer and got the t to flash when i put it in first gear indicating its wired correctly, I used 36500 as the calibration, then tried a few more ranging both ways with no luck so far, this was on jack stands with the tires just spinning, dont really know where to go from here, my buddy did the wiring and has the speedo healer going into the back of the aem, the toyota vss clip is spliced into the honda wiring the way the full blown diagram said to.. any help would be greatly appreciated, I wanna get this working so more people can do this easily in the future too

Originally Posted by 99SH

I was browsing around the internet to see if I can find the frequency output from our VSS sensors. Assuming the values posted in the forums were correct, the s2k VSS is ~37.6 times faster relative to the v160. Try to set your calibration somewhere around 37 and see what happens.

Originally Posted by p0staboy

Where are you seeing the T when you put the SH into test mode? When in test mode your dash should go up to about 7mph then stay their for a few seconds then go back down to about 1. That's what happends when I put mine into test mode. T should show up on the SH itself and when it does show,the speed on your cluster will go up like I said. If your cluster doesn't change speed your SH is not wired up correctly. Also which wire is hooked up to your AEM? I didn't have to wire my SH into my AEM

Originally Posted by passmans2kny

ok so would that be 37000 or 00037?, or 00370?

Originally Posted by 99SH

00037

Originally Posted by CD7SirAccord

That would actually be 3.7%. For 37% you want 00370

Originally Posted by 99SH

That would actually be 3.7%. For 37% you want 00370

Originally Posted by passmans2kny

ok so would that be 37000 or 00037?, or 00370?

Originally Posted by CD7SirAccord

That would actually be 3.7%. For 37% you want 00370