Is the vtec pressure switch an ok location to run a turbo oil line?
#11
Thread Starter
that hole is 10mmx1.25 thread pitch. so you would need a fitting that is 10mmx1.25 male to -4an male. Then you would need to make a oil line that would fit. most likely you will need 90 degree ends for the oil line.
#12
you quote two different sizes.. is it 1.5 or 1.25 pitch?
#13
Originally Posted by riceball777' timestamp='1315443448' post='20952637
that hole is 10mmx1.5 thread pitch. so you would need a fitting that is 10mmx1.25 male to -4an male. Then you would need to make a oil line that would fit. most likely you will need 90 degree ends for the oil line.
#14
Yes it is fine. See my thread about how I came to this conclusion:
https://www.s2ki.com/s2000/topic/852...#entry20671411
And here is a couple of vids comparing the oil pressure:
From Canton:
http://www.youtube.com/watch?v=jm8VH48ISSI
From oil pressure sensor port:
http://www.youtube.com/watch?v=VV0AVD8O1R8
Note: Although there is more pressure at the Canton (before the filter) it resulted in dirty oil and hence a clogged and stuffed turbo.
https://www.s2ki.com/s2000/topic/852...#entry20671411
And here is a couple of vids comparing the oil pressure:
From Canton:
http://www.youtube.com/watch?v=jm8VH48ISSI
From oil pressure sensor port:
http://www.youtube.com/watch?v=VV0AVD8O1R8
Note: Although there is more pressure at the Canton (before the filter) it resulted in dirty oil and hence a clogged and stuffed turbo.
#15
Thread Starter
Originally Posted by riceball777' timestamp='1315443448' post='20952637
that hole is 10mmx1.5 thread pitch. so you would need a fitting that is 10mmx1.25 male to -4an male. Then you would need to make a oil line that would fit. most likely you will need 90 degree ends for the oil line.
https://www.s2ki.com/s2000/topic/777...#entry18428025
Thread
Thread Starter
Forum
Replies
Last Post