Looks good but you should undercoat or line-x them. When particle board gets wet it swells up to double the size and crumble apart. Paint won't protect them

 

BUmp!!!
Just doing the DIY what the hell is that

 

The two pieces on the outside are CF to flow with the Downforce CF sides and the front splitter. They come from a universal front splitter originally for the 350z. I've had them on for almost 2 years now. You can see them here in this pic.





You can buy them on ebay for $105 CF and $45 abs plastic. I chose CF to match the rest.

They do need to be cut slightly so that they dont run into the exhaust tips. All you have to do is hacksaw about 3 inches off and it gives it a nice clean shape for the exhaust tips.

Hope this helps.

 

another pic

 

how did i miss this?! i am going to have to do this asap. thanks for sharing!

 

Lol i already have a set... ^.^

 

Im making it now, the cardboard is the most important part, making sure it will line up how you want it.
But after your bumper ends, the fins are just poking out into nothing?
He figured at this point why not at a plank of wood ontop so the wind doesnt actually get up in the bumper theres a second supporting spot for the back of the fins. (by back i mean the parts you cant see while looking from behind

 

any update if these will work on ap1?

 

Bump. For later

 

Its2klean, was this b4 the gp diffuser? I think I might take a crack at those side rear pieces since its taking gp fab soooo long...