Are you going to offer a polished version?

 

doesnt look half bad!!! way better than when i was doing the burning in my garage on my arc knob.....that blotchy stuff you are getting,.....heck i dont know what causes that,...i seemed to get it 50 percent of the time. i think more or less the flame splatter was causing it.

 

Yeah I am going to sand it back down tomorrow and try again and see what I get.

As for a polished one I believe so. I need to get a good polisher as I was wanting to offer polished for the stainless steel ones as well.
I know polished when burnt looks much richer in color than the brushed does.

 

The burnt knobs look good. I think the brushed finish looks a lot better than the polished ones. I might be interesting depending on pricing.

 

I want one if it's heavy. I have a m1 stainless knob from a while back that I love the heavy weight of.

 

It's not as heavy as my stainless steel ones. Being titanium which is a fairly light metal it is only 2/3rds the weight of the stainless steel.
It weighs about 280 grams.

 

Yeah I figured, but it would be nice to have it weigh a little more than the stock aluminum one.

 

Found this on here when searching for oem shift knob weights


OEM AP1:175 grams

OEM Ti: 284 grams

OEM AP2 :I would say ~250g since it weighs only slightly less than OEM Ti

Moddiction stainless 460+ grams

Moddiction Titanium 280+ grams

 

anyone know how much the ARC Titanium Shift Knob weights?

 

not sure but i know the oem Ti is heavier.
if the moddiction ball is that weight it will be great