How do you use the wood for leverage with the rubber??

 

Love j's exhaust's but do you not think it hangs too low in the bumper cutouts looks a little lost. Unless its camera angle.

 

hard to explain. you basically put one end of the stick against the hanger and hold the other end. find some sort of pivot point on the car and put the middle of the wood on it. then gently pull. the hanger will slide right off.

Silicone spray is good to keep around to lube all the other rubber parts in the car, like bushings

 

I'm gonna install my Berk HFC and see if the rattling is fixed permanently. Also here's hoping the drone at cruising speed is minimised.

 

reviving an old thread, i'm planning on purcashing one these bad boys soon. How goes the drone and rattle after 7 months of ownership?

 

Want one of these eventually too! Love the look and want to pair it with the J's Diffuser some day. though it seems these bad boys run quite high. If you don't mind me asking, what did you pick this one up for?

 

You can pick one of these up by going to www.gotuning.com . All said and done it comes to just under $1,500 including shipping.