Ok so I did a bat relocation yesterday and finished all of the SOS re wire kit except for the in tank portion yesterday.

This morning I pulled the in tank out and followed the directions the only thing I did was cut the in tank ground brass thing that clips in to the in tank pressure regulator plastic housing and up the gauge wire on the pump +12 power wire.

Now when I turn the key on the pump fires up I can hear it just fine! but no fuel out the outlet.
Could it be running backwards?? followed the directions, it has POWER.

 

BTW car ran fine yesterday after relocation and 1/2 SOS wire kit.

 

Pumps priming, no fuel... no clue

 

Reversed polarities!!! Lol always check your work, wires were right terminals on pump wrong lol.

 

The clip only goes one way and all I did was swap the +12. no clue how it happened but yup! Lol

 

Car idles a full point richer after wire kit. Hopefully re tune will help at redline. Last dyno session afr's were starting to fall off towards 7-8k.