cracknut

i don't put my helmet on or buckle the belts until I'm staged in pre-grid. Gives me plenty of time to relax, adjust to being in the car, etc.

msweeney

Did you get your bitchin' PTH shift knob? Also, when are we going to see you again? I need to fix that damn kill switch panel that didn't cure right.

cracknut

You might consider leaving in the A/C and factory windshield vents so you can run the defogger and get some rain experience w/o having to slather dish soap all over.

Greg W

Pacific Throttle House shift knob is likely resting on top of the K&N FIPK box in my living room, which will next be sat in by yours truly in exactly 13 days. Next shop stop will be for a post-K&N intake tune, then the e-steering dead weight removed. Can fix the cover (and install the wiper harness) at that time.

Ps does the 908 miss my sled?

Greg W

Crack nut, that horse left the barn already, interior's been gutted of all HVAC components save a fan blowing through the center vent. A/C is just dead weight in the engine compartment right now.

Mr. Nelson

Looks great! Understandably this was done a couple years ago, but I recently, this past week, have cut my center column to fit an OMP WRC-R XL to fit into my car. I was very hesitant at first, but saw really no other way, as I was not about to cut part of the seat and ruin it's structural integrity. I can now breathe a sigh of relief knowing I'm not pioneering uncharted waters. My issue right now is getting the seat lower. I ended up going with the planted floor mount, OMP sliders, and OMP sidemounts. I see you went with a custom floor mount and are a lot lower. I have to try and figure out that piece now as the seat is crammed in there and trying to get a good seated position is racking my mind. I also included a couple of pictures of the rollbar I went with I bought off of another member who had bought it from race labs.

https://lh3.googleusercontent.com/sl...w2430-h1366-no

https://lh3.googleusercontent.com/pK...w2430-h1366-no

https://lh3.googleusercontent.com/j0...=w1632-h918-no

https://lh3.googleusercontent.com/_z...=w1632-h918-no
Rust has been cleaned up since initial install of course.