I know the side S2000 badges are removeable with fishing line, but what about the front and rear Honda "H" logo badges, are they just stuck on or do the panels beneath have drill holes? I'd love to remove them (especially the ugly front one) but need to know what it looks like underneath first.

 

There are two holes behind the front and read body badges.

H and A accessories - site sponsor has instructions on how to remove and replace with the black chrome package which gives you all the information you need to remove them.

 

How about when putting on Rick's S2000 badges? Instructions included, or maybe I should READ THE MANUAL?

 

He sends you instructions, but they are the same thing as the H and A instructions, except you don't want to put tape on all sides of the H since Rick's badges are larger. You make a T on the bottom of the H badge, where the length of the T (I) is the center of the H badge so you can line up his badges.

Takes 10 minutes in the heat of Arizona to remove the H badges, get the goo off and install Rick's badges.

 

The Front H was a bisnitch to get off. I broke it in 5 pieces before I finally got it off....

 

Same here... then I logged onto s2ki and found out that there where 2 clips behind it that I could've used to remove it a lot easier.

 

[QUOTE]Originally posted by RSXTypeR
[B]
Same here...

 

yeah but if you take the emblem off...then arent there hole in the back?

 

i used a credit card and dental floss to loosen it up and then pulled it right off. after to get the black residue off i used goofoff. hope that helped. o yah, i dont want to make it seem easy, cause it was a bitch to get off.