i just installed an intake. i should pull the ecu and have it reset correct?

 

i'm going to do this today along with the MAP sensor whack to see if it helps my stalling and bogging issue. unfortunately for me, this happens EVERY time i come to a stop....

i just want to make sure I do it right.


-warm up the car to normal driving temperature.
-turn off the car and leave the key in the ignition but at the "off position" so that nothing electronically is working?
-pull the 7.5A backup fuse.
-use this time to disconnect the MAP harness and give it a few good thwacks, then reconnect as tightly as I can.
after about a minute or more, replace the 7.5A fuse, start the car and let idle for 5 plus minutes.

and thats about it right?


i know this thread is old but i didn't want to make a new one.