I just installed a J's Racing Strut Tower bar on my 2006 S2000 and it touches my PRM Intake. Will this be a problem?

 

touching it shouldn't cause any problems really. unless it's putting a lot of pressure on it to the point in which it forces it lose from the throttle body. then you could run into some problems... if may become annoying as i'd assume it wouldnt make some noise... but both of these issues are at your discretion.

 

If its rubbing the intake...over time it will create a hole in the PRM intake tube. This has happened before with the Spoon STB and AEM intake back in the day.

 

I had a prm you can put a small piece of solid
rubber in between