would it be possible to fabricate a silencer for this exhaust? it would be great if you could tone it down a little for cruising, then remove the silencer at the track (or when you just feel like hurting people).

i'm no metalurgist so i'm not sure what's invoved in drilling holes into a Ti pipe. what do you think?

 

I think a drill is required for drilling a hole .. and yes it's possible, but would cost you lots of money

I think there was a possibility of the J's silencer fitting in the Amuse exhuast..

 

thanks bob villa, but i don't think a stanley power drill is exactly the right tool for this job. i was hoping for specifics from someone with experience working with Ti.