Hi,

Was wandering if anyone had a PINOUT diagram for the CRUISE CONTROL MODULE... I'm trying to find more info on how to hard wire it to my AUS SPEC S2k.

Any help/diagrams would be greatly appreciated.

Peace.

 

Answer for AP1
-Connector is light blue
-Connector is located under the left side dash-US
-Connector is on the dashboard wire harness B branch (I.e. Left hand )
-Connector is 14 pin

With master key way at 12 o'clock
--1 through 7 across top row (4 under master keyway)
--8 through 14 bottom row

1 brn/why Actuator clutch
2 gray brake input
3 blk G402
4 blk/ylw fuse 6
5 why/blk brake input
6 lt grin/red set signal input
7 lt grin/blk resume signal input
8 not used
9 brn motor open
10 blu/ylw indicator light control
11 brn/blk motor close
12 why/blk vehicle speed input
13 lt gr power input
14 pnk disengage clutch input switch

Hope this helps......

Utah

 

 

Love you guys.



I'm going to attempt to hardwire it to an AUS SPEC S.. May create a DIY if I cbf.