If anyone has F20C1 blueprints they would be greatly appreciated - If anyone has tried any hardcore work like decked blocks or iron sleeves etc. I'm curious to know what your outcome was next to mine - Thanxs - See you in the 2002 season! mamaspeed2001@yahoo.com: BURP!

 

I dont know of anyone around here that has sleved one but Jotec in Dallas has. I think the car they did put down 400+ Hp
to the wheels. Good luck trying to get them to tell you their secrets though. I know their engine builder a little bit and he is very reluctant to share anything.

 

I checked with Golden Eagle and Darton and neither of them have sleeve kits for the f20c. So i am going the other route with my extra block and had it overboared .25 and was going to use stock over sized pistons. then it dawned on me that stock pistons cost 498 while a set of custom JE pistons will cost 500. Am going to keep stock rods (forged) and we will see from there. I expect to pick my block up from the machine shop tomarrow.