Started this morning, did my first valve adjustment a couple weeks ago. Tightened everything to spec and had a space of .8mm intake and .10mm exhaust. Cars not a daily driver, no known problems before this. I have stuff for a AP2 valve upgrade, but I'm Supposed to be going to Tail of the Dragon tonight, may have to wait till tomorrow... Did I f**k up myThoughts?

 

 

0.1mm exhaust barely has any clearance in between, you should have a cel for that. They should be 0.009 and 0.011inch on intake and exhaust side respectively or 0.012 on exhaust valves as billman suggested if you have an ap2v2

 

Ah sorry yeah incorrectly. I'm new to this forum so I dont know how to edit on mobile. Yeah those measurements are imperial. Pretty sure they are within spec tho

 

.008 and .010 imperial is what I used*