So I'm going to take off the H badges and use the "S" from the S2000 emblems I removed to cover up the holes. The reason for this thread is that I was wondering what tape I should use. I've read on here to use the 3m tape, but it seems kinda thick. I'd like to have the S as close to the paint as possible. Any suggestions? or do I just have to live with a little gap? Thanks in advance!

 

Bump. I need to know the answer to this also as I had my badges painted and they are going back on.

 

trying to do this from a handheld and not getting good internet-
but i think this might be the thin 3m

http://solutions.3m.com/wps/portal/3M/en_U.../Prod/Info/AFT/

if not, post back and we can try again!

 

iPhone????


sorry, just curious

 

nope... have only tried the iphone for pics-
using an mda. nice for email and most internet with good cells, but i was in a bad cell area, so couldnt get a good page load.

 

i use 3m outdoor mounting tape for a lot of stuff. its pretty thin.... you can get it at wal-mart for sure. it has a red plastic surrounding. get the grey tape not the clear one. its waterproof, and holds 5lbs/sq. inch lol

 

Hey man, take a look at these.

http://www.ricks2k.com/products/badge.php

or

http://www.ricks2k.com/home.php

for the home page that has other accesories.

There are steering wheel, center cap, and hood & trunk replacement badges.