ANVIL weighted and countersunk stainless steel shift knobs! 1 LB+
03-24-2010, 07:26 AM
#392
Former Sponsor
Thread Starter
Originally Posted by HondaGuy,Mar 24 2010, 04:20 AM
What's the height (w/o a nut) compared to a Voodoo?...lower, same or higher? Alot or alittle? Thx!
They are drilled out 1.75" deep into the knob so sit as low as possible really. Don't see how any other knob can sit any lower than this.
03-25-2010, 02:21 PM
#393
Moderator
Is there any option for a coating that would make it match the radio door, or the oem knob? Also, what about engraving the top with the H-pattern layout?
I am very tempted to buy one btw...
I am very tempted to buy one btw...
03-26-2010, 12:04 PM
#396
Former Sponsor
Thread Starter
I am expecting a shipment in today. Says out for delivery if not Monday. Once they are in I will take orders. Will take 1 day to start producing them but will have them ready to be shipped 2 days after getting the stainless steel balls in.
03-26-2010, 12:22 PM
#397
Former Sponsor
Thread Starter
UPDATE: Just got a shipment in. I will now turn ordering on. Orders should start shipping by Tuesday-Wednesday the latest!
These ones are a little bit different. They have a wider opening hole and will come with 2 nuts which allowing you to adjust the height if wanted and allowing the shift knob to tighten against them at lowest height. Adjuster nuts will be hidden inside the shift knob so you will not see any of them once installed. I will update with pictures over the weekend.
These ones are a little bit different. They have a wider opening hole and will come with 2 nuts which allowing you to adjust the height if wanted and allowing the shift knob to tighten against them at lowest height. Adjuster nuts will be hidden inside the shift knob so you will not see any of them once installed. I will update with pictures over the weekend.
03-26-2010, 12:34 PM
#398
Moderator
Any word on the engraving? What about a satin finish, like what TWM sells?
03-26-2010, 12:55 PM
#399
Former Sponsor
Thread Starter
I am waiting back on a couple places for the engraving. Place I was going to do backed out as they didn't think they could do it right.
Satin finish I have also been looking for a bead blaster as my compressor is not powerful enough for the air needed to media blast unfortunately.
I will do the satin finish but I don't have an eta or anything for that yet.
Satin finish I have also been looking for a bead blaster as my compressor is not powerful enough for the air needed to media blast unfortunately.
I will do the satin finish but I don't have an eta or anything for that yet.
03-26-2010, 12:58 PM
#400
Moderator
Ok thank you.
I will hold off on ordering anything until you get it sorted out.
I will hold off on ordering anything until you get it sorted out.