jst2878

Lambert

boyguan

Remember this is just the duct not an entire kit

The tubing runs like 6 per foot so it will be over 250 in the end

I really like the part but for the price I might make my own again

Price point for me was 150 shipped

I am sure at his current price he isn't making much profit as the part is all labor to make

ddess

I like them! Makes me wish I had an AP2 bumper

s132nr

230$ shipped for the Lambert kit with all hardware needed including ducts... I can see this getting over 350$ with everything needed.... Can you get a group buy going hopefully get the price down some

WASPcomposite

there is about an inch overlap with the bumper where silicone or epoxy can be used.

WASPcomposite

In order to lower the pricing we just started our GB with lower pricing.

I have seen few Lambert kits while installing our splitters for customers and it is a great kit. however, tubing and inlet size is at 2" on the Lambert while larger (2.5") tubing coupled with our custom funnel shape ducts significantly increases air flow.

nofearofdanger

I believe with the Lambert kit you have to buy the inlets separately to the rest of the kit.

rhouck

Lambert is inferior to this (2" vs. 2.5")

You can make your own for less (I did) but:
1. it definitely takes time (nothing is plug-and play)
2. it is VERY hard to get clean (i.e., not using rivets to attach)

I would have rather purchased these than go through the hassle of making my own

andrewhake

Count me in for $150 or $135 group buy!

Also interested in tubing as you had mentioned in the other thread. Thanks again for making these!

Croc

does it clear AEM V2 intake on the passenger side?