Odb's STR CR
#191
No problem, I'll measure it tonight.
I haven't seen the T1R turndowns in person, but they do look a little small and like they start pretty far back and don't have as wide a radius on the turn.
I haven't seen the T1R turndowns in person, but they do look a little small and like they start pretty far back and don't have as wide a radius on the turn.
#192
Thanks.
Robert Irish had the T1r EM on his CR at Crows. Thats where I was kinda like " "
I just found out the EM has a 70mm tip which is the same as my ASM tip(and I think that looks too small too) I like how Andrewhakes' Amuse tip is 100mm and fills the bumper hole more
Robert Irish had the T1r EM on his CR at Crows. Thats where I was kinda like " "
I just found out the EM has a 70mm tip which is the same as my ASM tip(and I think that looks too small too) I like how Andrewhakes' Amuse tip is 100mm and fills the bumper hole more
#193
Mine has a 3" diameter tip. The turndown isn't quite 90 degrees, but just about. It starts to bend 6" upstream of the most rearward point of the exhaust and the opening is just shy of 3" below the bottom of the straight section before it. It looks like it was bent on a mandrel with 3" radius.
Thread
Thread Starter
Forum
Replies
Last Post
iLuveketchup
S2000 CR Club Racer Edition
109
10-10-2014 06:34 AM
turbo8765
S2000 Racing and Competition
15
07-19-2011 03:51 PM