cleenyc99

already got rid of the front being it got hit, didn't think it would be useful

iamxpl

this thread cant wait to see the rest keep up the good work!

cleenyc99

tanks i'll keep you guys posted

cleenyc99

I figured it's about time to update this tread as I wait for my girl to get home from work. widened the bumper to line up with the fender so I get an even curve in the wheel well arch. after a lot of sanding it came out just as I wanted. it took a lot of work to get out the low spots and get the fender smooth. finished the metal work on the hood next I need to get all the dents out and block it smooth. also finished shaving the trunk.
fiber glassed the bumper then filer
DSC_0900 by liam r, on Flickr
DSC_0914 by liam r, on Flickr
DSC_0916 by liam r, on DSC_0917 by liam r, on FlickrFlickr
DSC_0922 by liam r, on Flickr
DSC_0926 by liam r, on Flickr
this filler works grate for filling the holes in the bumper made just for biting into plastic
DSC_0901 by liam r, on Flickr
I also got a new air compressor the thing is a beast 5rhp only pulls 19 amps on 1ph. swapped out my fittings for high flow fittings that where surprisingly hard to find but ebay had them. noticed a big difference when using these fittings. I also plumed 30 ft of copper tubing before my air filters to cool the air and get all the water out.
DSC_0909 by liam r, on Flickr
DSC_0910 by liam r, on Flickr

Grilla

This thread is inspiring! You do great work. Let me know if you still need door gap measurements, I can run out and take them.

cleenyc99

thanks that who be grate lets say at the body line. I've looked at a few s2k's and they seem to vary a lot, seen some that are tight and other look like a could fit my finger in so I'm not going to stress it to much

jst2878

Looking great. That repair is breathtaking, glad to see she was able to be saved. When do you think she will be on the road again

cleenyc99

thanks man. I'm aiming for and think I should be done by end of may so jun-jul

Langelo DeMysterioso

I was just thinking about you and this project over the weekend

cleenyc99

good to hear. how's it going AL? I didn't get a chance to say hi the other night