For those worried about durability... quite a few track days on F:20mm R:25mm setup.

 

I was curious is it possible to run 25mm all around on CR wheels with sprint springs without issues? I am planning on getting the fenders rolled and everything at Evasive.

 

do i need to cut the studs if i run 20mm all around with AP2v1?
I am planning on getting the fenders rolled

 

Shouldn't be an issue given your roll is aggressive enough.

 

Don't need to cut the studs on AP2V1s. Fender rolling/slight flare is a requirement

 

picking these up tomorrow for my ap2v2's

http://www.evasivemotorsports.com/Merchant...ode=WS-5511464C

will it fit fine?
do i need to do anything else besides the obvious fender modifications?

 

[QUOTE=travanx,Sep 22 2010, 11:42 PM]I was curious is it possible to run 25mm all around on CR wheels with sprint springs without issues?

 

kinda off topic but don't want to start a new thread was wondering if anyone makes 8mm spacers I know they make universal ones but im looking for some that come with extended bolts, or would I have to buy bolts separately...

 

I'm lowered 1.25" and want to run 15mm in the rear only with stock AP2v2s. No fender mods whatsoever. Factory alignment specs. Need hub-centric 15mm spacers with built-in studs so I can just remove the rear wheels, throw the spacers on, and bolt the wheels back on. Again, don't want to do any fender modifications.

Is this possible? H&R?

 

^ mm i dont think so, with 1.25inches lowered. with no roll? nah