I'm trying to finish the 38+page thread while reading every single post , instead of taking the time to post that maybe you could have just answered

 

yeah i highly doubt every single person is going to read every single page of a 38 page thread. new members are always coming to the forums so similar questions will always be asked. try to be courteous and answer if not then don't post at all


anyways, I just picked up some CR wheels from a local. I see that only 20 and 25 mm spacers work with these wheels because they come with extended studs. if i were to somehow get 10 or 15 mm spacers with extended studs will they work as well? maybe i am not understanding properly. thanks

 

sn0wman,

certain ap2 wheels, i believe for the CR especially do not have the opening on the backside of the hub to "absorb/swallow" the stock studs if a 15mm spacer with built-in studs are installed. I've attached a picture for example

 

kryptong - thanks for the clarification! i get it now. only 20 and 25 mm spacers are wide enough to "swallow" the stock studs (or else they will hit the back of the wheel). i think what confused me was when i saw poster in the CR section claim that he is using 5 and 15 mm spacers with his CR wheels. so there is absolutely no way to make spacers smaller than 20 mm to fit

 

You fail at being a d!ck. I just read through the entire thread & not once was my question been asked or answered. Upon further research on Option Selects Ebay site, they are just temporarily out of stock. I was not asking the "What spacers should I go with?? I'm lowered on blah blah blah I want flush fitment" that's been covered a million times, ass.

 

lol I see both sides of the story... It happens a lot that most people don't UNDERSTAND the search bar and that they can actually search this thread for key words. and I can see that yeah 38 pages is way to much to successfully get anything out of it because by the time you get to the part where its important you wont be able to pick up on it. Hope this helps anyone out there.

 

https://www.s2ki.com/...st__p__21170843
https://www.s2ki.com/...st__p__21540265

 

So how many times has the question been asked? Im the first person that did, you're statement was made to seem that it was being brought up on every damn page in this thread. Whatever I have found the answer myself, to everybody out there looking for some 15mm rears, Option Selects are currently sold out at the moment.

 

 

just installed my 25mm all around, 225 front and 255 rear, fronts are rolled and slightly pulled, rears are just rolled w/bumper tabs relocated, doesnt rub which is all it matters to me