Chaz's(H22toF20's) build thread
12-11-2012, 10:19 AM
#134
Registered User
12-14-2012, 09:08 AM
#136
Registered User
Thread Starter
Got the replica Cusco Type 2 bar, replica Comptech x-brace and Megan axle spacers installed!!! I had some pretty bad shaking and the axle spacers took care of all of it. The bars I'm even more pleased with. The front is more solid and more responsive. I'm going to have to get used to this awesome responsiveness! 3 cheap parts that work and fit perfect. I couldn't be happier with the purchases.
I think I might go on a bracing spree. All 3 bars I've bought have made a noticeable difference.
12-18-2012, 01:07 PM
#137
Registered User
Thread Starter
Didn't get much accomplished. I got the radio and power outlet working, and cleaned the battery terminals. I think my battery has a dead cell or I have a parasitic loss, she barely cranked over. Need to buy some tools to figure that out though.
12-24-2012, 12:21 PM
#138
Registered User
Thread Starter
Just looked through this thread and I'm amazed how far it's come but it still has a lot more.
Updated modification list as of today
Engine/power
custom stepped intake(3.5" into 3") with BPi velocity stack.
AUT cooling plate
Berk coated header
Hytech 3" test-pipe
HKS 75mm exhaust
Suspension/stance/chassis
TSW Nurburgring 17x9 +63 x4
Dunlop starspecs 255/40 x4
HKS Hipermax sport 3 coilovers
-2* front and -3* rear camber
Eibach front and rear adjustable sway bars
Megan toe arms
Megan axle spacers
PasswordJDM front strut bar
replica Cusco type 2 brace
replica Comptech x-brace
Exterior
APR bumper
Healtoe exhaust cap
Things that need to be put on when I find time.
Hondata gasket
Professional Products 68mm throttle body
AEM V2 EMS
Megan tie rod ends
buy front camber kit
new alignment(-3* camber at all 4 corners)
Hawk HP+ pads
Challenge stainless braided lines
Powerslot rotors
Updated modification list as of today
Engine/power
custom stepped intake(3.5" into 3") with BPi velocity stack.
AUT cooling plate
Berk coated header
Hytech 3" test-pipe
HKS 75mm exhaust
Suspension/stance/chassis
TSW Nurburgring 17x9 +63 x4
Dunlop starspecs 255/40 x4
HKS Hipermax sport 3 coilovers
-2* front and -3* rear camber
Eibach front and rear adjustable sway bars
Megan toe arms
Megan axle spacers
PasswordJDM front strut bar
replica Cusco type 2 brace
replica Comptech x-brace
Exterior
APR bumper
Healtoe exhaust cap
Things that need to be put on when I find time.
Hondata gasket
Professional Products 68mm throttle body
AEM V2 EMS
Megan tie rod ends
buy front camber kit
new alignment(-3* camber at all 4 corners)
Hawk HP+ pads
Challenge stainless braided lines
Powerslot rotors
12-26-2012, 10:36 PM
#139
Registered User
Thread Starter
Intake manifold is off!!! Took 3 hours but I got it. Probably the hardest thing I've done on a car. My Preludes manifold was pretty rough but this was on a different level lol.
