CDTAudio and OZ Audio Sub (ID?)
Thread Starter
Registered User
Joined: Jun 2011
Posts: 65
Likes: 0
From: Fremont, CA
CDTAudio and OZ Audio Sub (ID?)
I am finally getting around to looking under the hood of all my stereo pieces from the previous owner. I found that I have a US Amps XT1600.4 running in 3 channel mode to 2 CDTAudio 6.5 (with ~1" tweeters) components and then bridged on channels 3 and 4 to an OZ Audio 10.
I can't tell which models/versions of these products I have so I don't know their RMS Watts or OHM values. Any ideas?
No idea about these separates.
Supposedly, the RMS on this is about 700, but I'm not sure how to tell if this is a 2ohm (10.2 model) or 4ohm (10.4 model) version. I'm guessing that since it has two sets of terminal leads that it is a Dual Voice Coil (DVC).
The previous owner/installer connected:
+ lead to DVC(1) + on side 1
- lead to DVC(2) - on side 2
then took a wire from DVC(2) + on side 2 to DVC(1) - on side 1. Not sure if that indicates ohm options...
Any leads would be appreciated.
I can't tell which models/versions of these products I have so I don't know their RMS Watts or OHM values. Any ideas?
No idea about these separates.
Supposedly, the RMS on this is about 700, but I'm not sure how to tell if this is a 2ohm (10.2 model) or 4ohm (10.4 model) version. I'm guessing that since it has two sets of terminal leads that it is a Dual Voice Coil (DVC).
The previous owner/installer connected:
+ lead to DVC(1) + on side 1
- lead to DVC(2) - on side 2
then took a wire from DVC(2) + on side 2 to DVC(1) - on side 1. Not sure if that indicates ohm options...
Any leads would be appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
JohnKaznecki
Archived Member S2000 Classifieds and For Sale
16
May 13, 2009 06:53 PM
MrXpSyChO
S2000 Electronics
26
May 21, 2004 05:41 AM