Well I just finished prepping the head/block for the ARP studs I'm about to put in and the install instructions are a bit vague. I know I will use the ARP moly lube on the nuts/washers/top thread of the stud, but I don't know if I'm supposed to put moly lube on the thread of the stud that goes into the block. I wouldn't think they would need it as they are being screwed in until they hit the bottom and they are stationary when torquing. I just cleaned the block threads extensively and they are ready for the studs to go in.

Thanks ladies.

 

Answer found, I do use the moly lube on both ends of the stud. Locked.