Just got my ID 1000 for my AP1 (Inlinepro rail)
It did not come with the red adaptor that is in the picture, do I need it or do they fit as they are?

Thanks
Roi

 

My 725's were bare as well. Fit just fine straight up. I reused the o-rings from the stock ones. Lots of motor oil lube

 

The ID 1000cc do not need the little caps to fit, they are machined to fit into the s2000 fuel rail.

 

Thanks guys

 

You only need the adapters when you are working with the smaller sized injectors, like the B,H,D, etc honda engines.

The newer K and F series stuff are all the same size as the standard Bosch injector.

 

Just tried installing them and they do not fit
the seat that they come with is to small for the honda manifold
what am I doing wrong???

 

There are o-rings top and bottom of the injector. Place the o-ring on the injector will a liberal amount of grease "on the o-ring". As boof said, it is going to be a bare!

J

 

So I am confused. I was looking at some bosch injectors and I found some for b series and some for k series. The b series injectors looked like they were a better fit then the k. Am i mixed up would k serie be what id want?

 

no you want the ones for the S2000, I will try and post a photo of them installed when I get home today. I didn't try to force the o-ring on my injectors, I just seated them on the existing rubber pieces on the manifold and they work perfect.

 

F series ID-1000cc

J