SA-72R 17x9.5 +47 fitment
#11
You are either new or incredibly isolated. So far the only thing ive seen you contribute on s2ki is you listening to your own voice, and its really not that sexy contrary, to what you think.
Good day sir.
Good day sir.
Last edited by s2000Junky; 09-28-2018 at 09:03 PM.
#13
I run the same wheel with a 225 Hoosier which is pretty close to a typical 255 with no issues on track. You will be fine with a good pull. I don’t run my car super low though. Check my build thread for pics..
#14
Pretty standard fitment stuff. Steve's car below:
17x9.5 +47 CE-28N on 255 Maxxis VR-1
I'm running these wheels (SA-72R) 17x9.5 +47 with 245/45 (tall). I have no problems - i'll be running 255/40 after these tires are gone.
more pictures here
https://www.s2ki.com/forums/automoti...1175355/page3/
17x9.5 +47 CE-28N on 255 Maxxis VR-1
I'm running these wheels (SA-72R) 17x9.5 +47 with 245/45 (tall). I have no problems - i'll be running 255/40 after these tires are gone.
more pictures here
https://www.s2ki.com/forums/automoti...1175355/page3/
#15
Community Organizer
#16
Community Organizer
Yeah I'm pretty sure with your current alignment and maybe the slightest bull you'll be fine. Just make sure to roll the front fender lip flat and trim the fender liner in that area if you haven't done so already.
#17
Pretty standard fitment stuff. Steve's car below:
17x9.5 +47 CE-28N on 255 Maxxis VR-1
I'm running these wheels (SA-72R) 17x9.5 +47 with 245/45 (tall). I have no problems - i'll be running 255/40 after these tires are gone.
more pictures here
https://www.s2ki.com/forums/automoti...1175355/page3/
17x9.5 +47 CE-28N on 255 Maxxis VR-1
I'm running these wheels (SA-72R) 17x9.5 +47 with 245/45 (tall). I have no problems - i'll be running 255/40 after these tires are gone.
more pictures here
https://www.s2ki.com/forums/automoti...1175355/page3/
#18
Don't know if your question was answered. I'm running square with Wedssport SA-72R 17x9.5 +47, 255/40ZR17 tires with -3.0 camber front using offset RCA and -2.7 camber rear. Fenders are rolled in front with a minor pull and trimmed in rear with tabs relocated. No issues rubbing.
Thread
Thread Starter
Forum
Replies
Last Post