Pulled on a 350Z...
I was on my way back from the Palisades Mall on 287N...when a 350Z sat next to me for awhile and then took off. I looked at my Wife and she said, "are you really going to let him pass you like that? Go get him!!" So, I turned off my cruise control and rev matched 3rd @ 70mph and caught up to him shifting back into 6th. We were both closing in on some vehicles in the middle lane and I waited for him to choose a lane. He chose the left, so I took the right lane and noticed that there was a HUGE gap between the next set of cars. He took off on me so I rev matched back into 4th from 6th. It took me all of 4th, but once I hit 5th gear I finally started to pull on him. I looked down and saw 5th blink 2 times and shifted to 6th as I pulled about 4 car lengths in front of him. He then hit the brakes and I let off. We played a few more times, but we were pretty even until I hit 5th and I would start to pull on him. I was satisfied and gave him a wave and then took the next exit and headed home...
I could only tell he had an exhaust on the 350Z...
My S:
2003 S2000 w/ 63,xxx miles...
- Invidia Ti N1 70mm Single Exhaust
- Invidia 70mm TP
- ACT HDSS Clutch Kit
- ACT Prolite Flywheel
- AP2V2's wrapped in Star Specs (225/45/17 & 255/40/17)
- Koni Yellows w/ H&R Race Springs
- Alloy Craft Cooling Plate
- J's Racing Strut Tower Bar
So...pretty much stock and was a good kill for me!!

Proof that I am stock!! Lol
I could only tell he had an exhaust on the 350Z...
My S:
2003 S2000 w/ 63,xxx miles...
- Invidia Ti N1 70mm Single Exhaust
- Invidia 70mm TP
- ACT HDSS Clutch Kit
- ACT Prolite Flywheel
- AP2V2's wrapped in Star Specs (225/45/17 & 255/40/17)
- Koni Yellows w/ H&R Race Springs
- Alloy Craft Cooling Plate
- J's Racing Strut Tower Bar
So...pretty much stock and was a good kill for me!!

Proof that I am stock!! Lol
Thread
Thread Starter
Forum
Replies
Last Post
Steve54
UK & Ireland S2000 Community
36
Jun 26, 2003 12:20 PM





