Red H badges
Joined: Nov 2005
Posts: 3,452
Likes: 1
From: From the Desert 2theC
I had the same problem and had already attached the front one so I'll never know if I put the wrong one up front, but I followed the instructions to a T and think that they just don't fit in the rear.
So I broke off the pegs for the rear one, sanded it down and added more double sided material to it and attached it.
Still on and seems secure - time will tell.
So I broke off the pegs for the rear one, sanded it down and added more double sided material to it and attached it.
Still on and seems secure - time will tell.
Joined: Mar 2003
Posts: 3,962
Likes: 7
From: San Fernando Valley, CA
Originally Posted by MulderATO,May 20 2006, 06:32 AM
They had limit availability about a month ago, I think because they were not being made anymore (Death of the NSX).....
http://www.handa-accessories.com/s2000-03.html
Yep... says limited supply, silver and white are on backorder.....
Good luck!
To the OP, did you get them on?
http://www.handa-accessories.com/s2000-03.html
Yep... says limited supply, silver and white are on backorder.....
Good luck!
To the OP, did you get them on?
It had something to do with factory replacement vs. accessory pricing, with replacement being a helluva lot more expensive.
Thread Starter
Joined: Jan 2006
Posts: 253
Likes: 1
From: DC
Ok, everyone else was right. I was wrong. (And ricks2k.com's directions)
I was trying to fit the front badge on the rear. It all works now, though I'm not sure I like the red H on the front all that much. It's bigger than my old badge. I like the one on the rear though
Rob
I was trying to fit the front badge on the rear. It all works now, though I'm not sure I like the red H on the front all that much. It's bigger than my old badge. I like the one on the rear though
Rob
Thread
Thread Starter
Forum
Replies
Last Post