I've already read the two posts on Hard wired V1 installation? and Valentine One install help... , but now that I have the V1 kit and I'm trying to hardwire it up, I'm still a little confused as to where to tie in with the little in-line splicer that is supplied with the V1. Wires wires and wires. Without a manual, tis difficult to see where to punch in. Taking guesses with everything down there is scarey to me. Especially since some of the wires have to do with the airbag. I'm taking pictures while I do this so I can post them onto s2ki.com/faqs when I'm finished. But I'm unable to get it in there correctly without a bit of knowledge on how to choose the correct wires.

If you can scan a manual, or a few pages that would give me some clues, I will gladly add that to the faq once I create it as well.

Thanks!

 

[QUOTE]Originally posted by Schatten:
[B]

 

Sounds good then. I'll swing by a Radio Shack sometime tomorrow and do it right.