So the other day i went to change my wheel bearing (front right) and i couldn't get the abs sensor out of the spindle for the life of me so i took the alternative route and broke it, knowing i had a spare one form a 2002 at home. Drove the car home after removing the pink abs 30a fuse, installed the 02 sensor in my 00 which i assumed was the same (parts numbers are the same, just checked) and i still have a light on. The lights been on since saturday and i've driven the car every day since then. I figured it would reset at some point but it doesn't look like it's going away. I did the 4-9 OBD2 jumper and here are the codes i got
11, 12, 15 and 16

How can i reset this light?

Thanks

 

Would like to hear an answer to this as well.....

 

Bump

 

All of the codes refer to the Right Front and Right Rear speed sensors..

Codes 11 and 15 will stay until the ABS light is reset. Where as the other two will turn off when the system returns to normal.

 

so i ordered the fornt and rear pass abs sensors. I'll change them out when i get them and post back here, i expect to see the abs light not on after replacing these

 

That may fix the issue at hand but it won't turn the ABS light off. Like I said, codes 11 and 15 will cause the light to stay on whether or not the problem is fixed. You will have to reset the ABS light after you replace the sensors to clear all the codes.

If BOTH Codes are on like you say. I am guessing a wiring problem.

 

How do I reset it? I thought I read it should automatically reset itself.

 

Most codes will go off and the light will reset itself after it performs its self diagnosis. However, some will not as far as I know.

Now for resetting the light. I don't really know how to do it without a honda scanner. Maybe just unplugging the battery for 5 mins

EDIT: Here ya go playboy

https://www.s2ki.com/s2000/index.php...&t=674428&st=0