I have a question and probably someone can help me. I have an ap1 and I’m planning to swap my Ap1 headlights for the Ap2 headlights complete set with HID Ballats, Igniter etc…
I want to know if this is a plug and play swap. I don’t want surprises ones I’m doing the swap. I do know that they will fit perfect and I have seen the DIY but with the Ap1 Ballats and Igniter. I haven’t seen a complete swap with the Ap2 headlights HID Ballats Igniter and that’s what I’m concern about.
Is the Ap1,Ap2 headlights harness the same ? Is there an DIY in this forum that I haven’t seen?

If anybody can help me I will really appreciated, comments, suggestion are very welcome!!

*Thank you guys*

 

Any help guys??

 

im pretty sure it's PnP

it's only the tail lights that is hard(er)

 

yes, its a pnp
go to moddifications and parts.
thats where i got the info for my swap.

 

Yea I check mod and parts and they say is a plug and play. Is there any DIY on this forum by any chance?

 

https://www.s2ki.com/forums/index.php?showtopic=275318

 

Yea this is the DIY I was looking at but the difference is that I’m going to buy the original Ap2 HID ballats, igniter etc.. so I want to know if is going to be a plug and play with the harness of the Ap1.

 

It's much easier swapping headlights with ballasts, so yes it's plug and play.

All of your AP1 wiring will plug directly into the AP2 lights.

 

My question will be then that there's a wire that goes from the ballats to the harness of the car and I want to know if is plug and play because on the Honda diagram and part number are different.

 

Yes it is totally 100% plug and play!

All your AP1 wiring will plug right into the AP2 headlights.

Just pull the bumper off and swap...not hard