hey guys, i have a 2007 dbw vortech superchaged s2000.
i change the intake pipe with a silicone elbow .
which the intake sensors r too short, so i cutted and add a little longer with my own wires, and make it fit..
everything it's ok for months, but recently i saw a check engine light, so i drove my car to a mechanic shop, which they told me it's something with the intake sensor, so i checked the wires and everything is good, so i put it back, and go out for a drive, after a minutes of highway cruise, check engine light comes again...

so what do i have to do guys??

thx

 

Did you solder and shrink wrap the connections? What's the exact wording of the sensor fault?

 

it's says not reading correctly

i think it's something sensor error...

 

looks like you messed up the wires then.

 

i went on a cruise for 30 minutes today, no CEL on now...
not sure about it later...