Me and a couple of other guys r putting back my head...well anyways head is back putting all the stuff back and when it was time to start it we get no spark engine won't turn over....We r thinking we didn't ground it right...can somebody help me!!!!! we r not getting no spark at all so can anyone help

 

You might have forgot to connect a wire somewhere. If your skilled enough to r&r the head, you should be able to figure this one out.

 

yeah i think we forgot to plug something its hard to think in the cold

 

 

There are two grounding wires that attach to the bottom drivers side of the block and one grounding wire that goes to the back of the head. Its a real bear to get attached, but not inpossible. How far did you take the engine down? Did you just take the head off?

 

Check the main PCM ground attached to the back of the cylinder head, closest to the firewall.

 

just installed the head re-check to see if everything is connected.. Well i wondering how many ground wires r on the head

 

There is really no need to start another thread on an existing problem. It loses continuity. I'm merging this one with your other one.