We do. We also have board members who part out s2ks. PM me if you'd like info on some of them.

 

I'm good thanks as my EPS is fixed. Was just hoping someone could get one in the US to experiment on.

 

Im working on trying to get a whole rack so I can swap it, then donate my old one to Billman. Have a couple questions, can I perform an EPS relearn my self without any special machines? Can you just swap out the torque sensor? Will I need a relearn when I swap racks?

 

The EPS neutral position can be re-learned with a paper-clip. lemme know hwen you are ready.

 

Yeah I saw that some time ago, I cant find the thread on my phone, care to share the link?

 

I dont have a link, I know how to do it

 

Just tried ti attempt a relearn, i jumped pins 4, and 9 of the obd II plug but couldnt even get the EPS light to turn off when I switched the ignition to the on position

 

There's a method of doing it without using pins in the workshop manual. I don't have it though...

 

You have to find the neutral position. It may be left a bit. Once you get it to go into the relearn mode, immediately continue the procedure with the wheel center and 45deg left..

 

Do i short pins 4&9 in the obd or dtc? I have an MY02