Retaining ring holding shift boot
Thread Starter
Joined: Jul 2005
Posts: 1,164
Likes: 2
From: NY, NY
Retaining ring holding shift boot
I need to remove the retaining ring over the rubber shifter insulation, I don't want to break it so I'm wondering if anyone can shed some light on my problem for me, any help is appreciated 
Moderator
Joined: Oct 2000
Posts: 30,809
Likes: 15
From: Sydney
It has four little clips at the NE, NW, SE, SW diagonals. If you push the rubber in towards the shifter you will see the slots. You can slide a fine screwdriver in there and wiggle them out one at a time.
Thread
Thread Starter
Forum
Replies
Last Post
