The S2000 Forced Induction Forum is a great forum, and I think one that will flourish in the future. As such, I've been compiling threads/info/etc for some time, trying to learn the in's and out's of this system. I personally choose AEM, because I felt it was the best bang for the buck and did everything I needed it to do and more.

We have a great pool of general knowledge, one that I think the S2000 community could benefit from. I would like to see us work together, and gather information on whatever the issues are, and collect it here. I'll continue to edit this initial post as more information becomes available and in this thread.

This should get us started.



[AEM Official Site & Forums]

• AEM Electronics
• AEM Forums

[AEM Setup & Config]

• AEM Base Map Setup
• DIY AEM Tuning How-To
• AEM Sensor Calibrations
• Startup Configuration
• Idle & Startup Config
• Partial Throttle Tuning
• Understanding Fuel Tables
• Mapping Wideband Voltages to AFR's
• Flex Fuel Setup and Config
• AEM Cold Start Config
  

[Electronic Boost Controller Setup]

• Programming Electronic Boost Control
• Manipulating Spool
• Boost Compensation Setup
• Increasing Turbo Spool
  
  

Datalogging & Display

• AEM 19-1 Serial Gauge
• Serial Gauge Setup
• Virtual Dyno and AEM Logging
  

Wiring & Pinouts

• AEM V2 Datasheet
• Wiring Extra Sensors into AEM
• Additional Info on Sensor Wiring and Pinouts
  

[General Tuning]

• How to Read E85 Spark Plugs
  

 

How about adjusting a two step RPM limiter for launch control (not building boost)

 

Good question, I'm hoping to get some good launch control (2step) info shared here as well.

 

this has got to be one of the best thread for any one of us with an aem ems.

 

That's the plan to keep it all together and accessible, but not only that, to develope discussion as well.


Sent from my iPhone 5 using Tapatalk.

 

Great idea Adam

 

This is great. I am looking forward to digging through all the info haha

 

great idea, i wanna learn more about my ems so this is perfect

 

Added IOS Digital Dash Display, I think once it's complete, will be another great tool.

 

Added v2 datasheet / pinout & how to tweak startup configuration.