s2sik

i also have a mishimoto installed on mine. i have installation pictures in my build thread somewhere along with the fans. unfortunately the fit was not good, a mounting point on the bottom had to be bent to get it in accordingly with the mishimoto fans. my radiator cap also failed, so i went with a spoon cap. i got a little of dripping from the bottom where my sensor mounted since i didnt have any teflon wrap handy, that was a pain because then i had to pull a quick switcharoo while coolant was already in there. havent had any problems after the install, cools great. i also used honda type 2, type 1 was already phased out in my area

Boss-S2K

I actually had to dremel down my fan shround a bit to make it fit into where the radiator holds it. Other then that, perfect fit.
May get kind of tight however depending on your current set up.

zeroptzero

I wish I had done that when I installed mine, I had a chunk of welding material come loose from inside the radiator and it eventually jammed my thermostat in the open position, so the engine would not heat up much. I ended up replacing the thermostat.

S2K2226

All done and everything is running nice again.will keep an eye on the cap and fluid levels.



Thanks again to all who helped out, I could'nt have done it with out you!