break into the 12s
Originally Posted by Silver S2k4,Jul 12 2005, 03:16 PM
I did break an axle and it was on street tires. I launched WWAAAYYY wrong, and after I learned to launch at 2,500rpms I ran consistent 12.7-12.8 at 111-112 all on 6.6 psi and the ACT/Comptech clutch setup and cutting CONSISTANT 2.0 60' times. Before that, on 4psi and stock everything I managed to squeeze a 12.96 pass at 109 but only one time. 4psi!!!!!!
So it is VERY possible to break 12's with little FI work to the S and I have done it. The drag radials are sitting in my garage and the pulley just came in. I'm going outside and putting this shit on and then getting everything tuned with the EMS and will be shooting for low 12's and MAYBE, just maybe i get somehow get into the 11's without braking anything.
So it is VERY possible to break 12's with little FI work to the S and I have done it. The drag radials are sitting in my garage and the pulley just came in. I'm going outside and putting this shit on and then getting everything tuned with the EMS and will be shooting for low 12's and MAYBE, just maybe i get somehow get into the 11's without braking anything.

Wll after I broke an axle I was scared to launch at 4k like I usually do so I tried 2500 and slipped the clutch, car just went, was gonna bog but since the SC boosts at low rpms it picked itself right up. Worked pretty well actually. I use the same strategy on the street, but I'm going right now to get my slicks on so it will be very different.
Originally Posted by Silver S2k4,Jul 13 2005, 07:55 AM
Wll after I broke an axle I was scared to launch at 4k like I usually do so I tried 2500 and slipped the clutch, car just went, was gonna bog but since the SC boosts at low rpms it picked itself right up. Worked pretty well actually. I use the same strategy on the street, but I'm going right now to get my slicks on so it will be very different.
Thread
Thread Starter
Forum
Replies
Last Post
JennyEliza2G
S2000 Forced Induction
46
Sep 28, 2005 09:41 PM




