Comptech SC Inlet Elbow
Thread Starter
Registered User
Joined: Apr 2007
Posts: 487
Likes: 0
From: Lexington, Kentucky
Comptech SC Inlet Elbow
I am deleting my SC's by-pass valve and the recirulation hose to run an open breather and an BOV. Thanks to John Z and mr grand prix 
I want to keep a clean look under the hood- not just to cap off the intake ports in the inlet tube.
I measured the inlet tube on my system and it seems to be 3.5" on the filter side, and 3.25" on the blower side. Are these correct?
Do you guys think this tube would work?
http://www.verociousmotorsports.com/Shop-b...34Pa38Ta38Nahr0
Not bad for $70, I think....
I want to keep a clean look under the hood- not just to cap off the intake ports in the inlet tube.
I measured the inlet tube on my system and it seems to be 3.5" on the filter side, and 3.25" on the blower side. Are these correct?
Do you guys think this tube would work?
http://www.verociousmotorsports.com/Shop-b...34Pa38Ta38Nahr0
Not bad for $70, I think....
Registered User
Joined: Dec 2007
Posts: 3,947
Likes: 8
From: Raleigh, NC
I don't know if it will work, but SiliconeIntakes.com has very nice couplings and t-bolts for cheap.
Thread
Thread Starter
Forum
Replies
Last Post