e85 supporting mods for boost

Reply Subscribe

Thread Tools

Aug 20, 2019 | 01:43 PM

#21

landapanda

Thread Starter

Registered User

Joined: Nov 2017

Posts: 152

Likes: 2

From: Oxnard, CA

Quote:

Originally Posted by Nfinitecc

A An -10 on the turbo itself would be a nightmare to fit and completely unnecessary. I have a -10AN on the pan but the standard angled barb on the turbo is more than sufficient. If you’re using a PFAB manifold you’re going to have to clearance the motor mount to even run that! The PFAB manifold shifts everything down just a bit making a lot of small interferences.

I realized this and had quite a few frustrating figment issues that required me to trim down the pfab t25 flange and a smidge of the motor mount. I rounded the edge of the flange to get clearance for my feed line setup since it’s a -3AN fitting and sanded down the motor mount to fit the -10AN 45deg fitting for the drain