http://pg.photos.yahoo.com/ph/wahjei/album...ahjei/my_photos

I am not sure if anyone brought this up, but I actually found a way to place the HID thingy inside the new headlights without having to trim the little circle holes. You would have to disassemble that HID thingy---the plug, and then feed the wires inside the circle holes first, then reassemble while it's inside the light housing.

I figured this was the better way to install it because the headlight costed $400 and the HID is only $135 something. I would rather distroy the plug than the headlight.

 

check your PM

 

I tried this as well when doing AP1 ballast on AP2 housing. I spliced the wires on the ballast to feed it through. This worked, but I ended up with AP2 ballasts for another reason, haha.

 

very nice!~!