well shortly after my test fire after the vortech install I went to restart the car and the motor will not turn at ALL

the motor didnt stall out I shut it off. Oil level was good and is fresh castrol oil.

only change was install of old ap1 tranny which went smooth no issues and the vortech kit

Im gonna try removing the vortech belt and the accessory belt to see if they are to blame

anyone have any other ideas on what to try?

 

try to turn the crank pulley before you undo the vortech. If it turns nice then check the starter for voltage maybe you left something unplugged. Good luck

 

Tried that no luck won't turn by the crank pulley bolt in any direction I even took the plugs out to make it a bit easier no go