Have the TSB 054 Done, Then CEL is on.
Dropped my car off yesterday to have TSB 054 done. when I went there to pick up my car today, the Check Engine Light appeared few seconds after I started my car. they asked me to pulled into their garage and helped me to reset it. they reset it, and tell me it is ready to go, then I start my car again, and the check engine light was on again. they plug the their computer into my car again, they tell me it is some thing about the check valve and the intake chamber. they again tell me that the car is good to go, this time I didn't restart my car, and drive back home. 15 minutes later, I made a stop, when I start my car, the CEL was on again
. It was late, and the only thing I can do was drive back home. Do you guys have any ideas???
The dealer that performed the TSB is about 70 miles away from my house, but I think it is the biggest Honda dealer in the area, and that is why I bring my car to them. However, there is a small Honda dealer right in my town. I don't really trust them. Do you guys think I should go back to the dealer that done the job, or bring it to that small dealer in my town.
. It was late, and the only thing I can do was drive back home. Do you guys have any ideas???The dealer that performed the TSB is about 70 miles away from my house, but I think it is the biggest Honda dealer in the area, and that is why I bring my car to them. However, there is a small Honda dealer right in my town. I don't really trust them. Do you guys think I should go back to the dealer that done the job, or bring it to that small dealer in my town.
Thread
Thread Starter
Forum
Replies
Last Post



