Hi all.

My car's been in at the dealership getting some work on it. New master clutch cylinder, new 1st and 2nd gear syncros, new clutch bearings, and new clutch plate.

What I was wondering is, how many km's (or miles) should I allow to run these in? During this time should I avoid Vtec?

Thanks in advance

 

I say a 500mile break in, anyone else?

 

Thanks Hondamanwill...

 

Why? He doesn't need to break the engine in again. Just warm it up before you drive it hard.

 

I would think that since it is the drivetrain and not the engine vtecing would be OK. However, I would be gentle with the shifting and clutch engagement. Let all the parts get seated well, before speed shifting trying to get 2nd to squal. 500 miles sounds good. My 2 cents.