On a side note, I hope you are upgrading the PCV valve, or doing a Krank Vent... Boost in the crank case = boom.

And, FWIW, I LOVED my T1R-EM 70mm single. Made great power, and was fairly quiet (as far as aftermarket exhausts go). Also, the down turned tip = no crap on your bumper from not running a cat.

John

 

I am lucky, MADjdm and I are are going to have a similiar set-up, w/ him doing it before me and Jeff doing my install as well, I expect smoooooth sailing, haha. I talked to Pang today, Twinscroll manifold is just 7 weeks away . MADjdm, you have to hook me up with a COMPLETE parts list. I am dropping off my car to Jeff's for the clutch/flywheel install this friday, hopefully your cars still there so I can take a peek, looks good

 

Looks real sick. My car goes for tuning tomorrow or thursday. Looking to make over 500whp now on the ELTM. Love the way you put her in there with all the exhaust wrap and the gold tape. I should use that gold tape instead of the DEI Silver tape.

Your turbo also comes off very straight and mine has a hard angle that sets my ELT manifold apart from others. Im sure its gonna run great. Really wanna see some numbers from this setup! Sick GTR and interesting white car. haha

 

i was wondering is it easier to get the boost control to boost Hi/Low than the button?

 

yeah, it's a 240z, I've seen him on hybridZ before. I also have a Z.

 

jwa4378 - that's correct, its a 74' with an RB25DET, custom sheet metal white body

Also have the supra pcv mod

Joey - can't wait to see that twinscroll setup, its gonna be nuts - my parts list on the first page is pretty complete, but I've honestly made at least ten trips to homedept for random stuff to make it work. I might be there on friday to pick up my beater, but ive been doin the build at my place so no s.

Andy - you doing a race gas tune for the new mani? Better take some vids. The vband housing gives you some flexibility when clocking the angle which i though was cool

 

Great build- absolutely first rate.

As long as we're getting off-topic, I have two questions:

- Where can I get those hoses to rotate the heater hoses/valve?

- That heat shield tape looks like kapton or something. Source?

Thanks!

 

The heater hoses are actually my oem ones. I cut about 2 inches off one piece and rotated them.

The gold reflective sheet is available from Full-Race or Summit. I think its $30 for a 12x24" sheet. Surprisingly, I still have some left over after wrapping everything

 

sick sick sick

 

madjdm your built looks sick!!! hopefully all my parts will be in by next week so jeff can get it installed. sounds like we may have similiar mid sept. evans dates....us newly boosted metro guys (and the vets ) will have to meet up soon!