burnout = eminent breakage.


can a puddy mod stage 3 withstand ALOT of abuse? whats done to it? thanks

 

No word to think---except "Abuse"

 

Did you drain the old diff to see if there were any chunks in the fluid before ordering a replacement??

 

Build em like you drive em.

 

damn............. I was barely able to keep up with a C6 Z06 (slighly started to catch up) at 550RWHP, either your car is a beast of that F---- was modded

 

Just don't be an idiot with the stock drivetrain parts and you should be fine. Its not a drag car and if yo utreat it like one these are the results you get. particularly when yo udouble and triple the amount of hp it was built to see.

 

Yea I dont really plan on doing doughnuts and stuff, judging by all the incidents I have read now lol

 

Grab the output shaft cups and shake them. If the have a ton of play the diff is shot. It's pretty obvious. There is some play in them stock, but they'll wobble like crazy when the caps shatter.

 

its prob the axle I did the same thing a few weeks ago jack it up and start the car put it in first and wait for the grinding...grab each wheel and try to stop it...if one stops you snapped an axle or if neither of them move its your diff

 

no, i'll inspect old one once i get car running again, worst case i have a spare diff, about half of the way done, if it stops raining, i'll finish tomorrow

actually, i'll go ahead and drain fluid when it dries up outside to see what comes out