I haven't weighed it, but it can't be more than 3 or 4 pounds, if my memory of lifting it off serves me well.

 

I checked mine out and there is about 1/4" gap between the bottom of the STB and the top of the intake tubing where it joins the manifold.

 

My comptech STB does fit without the 3mm spacers, but it rests on the rubber coupling. After some driving and moving around, the stb rubs against it and wore it down alittle. I didn't want to take a chance, so I made those spacers.

The Comptech STB itself is made out of billet aluminum, so very light. It's those piller mounts that are a little heavy!

 

You need about 1/4" and maybe a bit more vertically and probably about 1/2" to the right of the stock intake tube (looking from the front of the car). I could be off on the measurements by a bit.

 

Are you sure?? ok, we will see, I am still thinking about the Comptech STB, hey, socal128, can you make me those washer/gasket? by the way, your Zeal B6 is mine before I believe..!! (did you buy it from Mass, my friend, Aaron?)

 

[QUOTE]Originally posted by demonderrick
[B]Are you sure??

 

Can't you just use washers (SS ones) from Home Depot?