Err.. I should say a Wrong done right:

I am an avid RC Heli modeler... I got the Muz Trunk holder/mat thing... the Velcro would stick. I took some CA (superglue) to the back of the Velcro to stick it to the trunk. (Bad idea to begin with, someone keep me from drinking beer next time).

Well, that didn't stick either... About 1 hr later, I notice it DRIPPED onto my paint. Yup, you guessed it, CA (superglue) is now in my paint.

I took scratch remove, etc... to it, NADA. It "looked" as if it was etched into my paint. I was shittxng.

Well, I took this stuf called which is basically an "unglue" for CA to the paint, thinking it couldn't get worse... Guess what? It took it off completely... 1 coat of wax, and she was good as new!

Note to self: Don't use CA on your car, escpecially near paint!

Beer thought,
Aaron

 

. Aaron ... please please stop and go to my site and get the instructions.

There is no need for glue and you can even install with or without the Velcro and cable ties.

It's all detailed in photos in the instructions.

Also .. here's a link to the same in the GB forum...

https://www.s2ki.com/forums/showthread.php?...?threadid=15419

 

This was before I read the distructions...besides, I couldn't get the zip-ties to work out so they would hold :-(

-- Aaron
p.s. I'll try again tomorrow, its late.

 

Did you do this before or after NXNW?

Kirk

 

After...
-- Aaron

 

That's what I thought.

Kirk

 

BTW, the product is called "Uncure", Green top, sold at almost all hobby shops.
-- Aaron