When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I used a large zip tie to help get the boot away from the adjuster..Tied the zip tie off to something back there and partially squeezed the boot off the cable.
I cut and welded my own towhitch today - pic´z are on my phone though. Will be painting it with rustprimer tomorrow and then a simple black paint to finnish it off.
Finished the new exhaust...it took a while to get as all places were back ordered......Finally in. Tanabe Medalion, with High flow cat. Not all the hardware was stainless so some was ordered from MC Master Carr. No rush to start it. I'll just wait till it comes in to fire it up.
Next on the list Hondata Flash...eventually it'll get a remote tune, but I want to drive it a bit with the Hondata tune, to get a feel for it. Will be doing a valve lash adjustment, since 07's are known to get tight from lean settings.
Removed the heat shield and added stainless steel brackets to hide the HFC...luckily we don't have a snif test in KY. I just like the stock look.
Not much room for error in fitting the cat. The stock insulation was reused. Plus about 1/4 inch of the sheild had to be cut off to clear one of the flanges.
Had to take a little time to try and center the mufflers, it favored one side. The hanger brackets had to be bent a little.
01-29-2020, 02:30 PM
